Original story published by AutoPulse Malaysia.
Back to news

Industry News Update · Original story

Omoda 5 Rear Axle Concerns Put Chery Under Spotlight as China Recalls 53,882 Vehicles

By AutoPulse Malaysia ·

Recent rear axle-related incidents involving the Chery OMODA 5 have brought renewed attention to vehicle safety, quality control and recall procedures. With a new recall campaign announced in China and a separate inspection campaign in Malaysia, questions remain about the scope of the affected vehicles and whether the cases are connected.

Chery is recalling 53,882 vehicles in China, including the Tiggo 5x and Omoda series, following concerns over a potential rear axle welding defect that could affect vehicle stability and driving safety.

The recall, announced by China's State Administration for Market Regulation (SAMR) on 6 November 2026, covers vehicles manufactured between 6 June 2022 and 31 December 2023. The campaign will begin on 27 November 2026.

What is the technical concern?

The reported defect involves insufficient welding at the connection between the rear axle trailing arm and its sleeve. Under extreme conditions, the welded joint could fail, potentially affecting rear-wheel control and increasing the risk of an accident.

Chery will inspect the production date codes of the rear axles and replace components identified as belonging to the affected production batch at no cost to vehicle owners. However, this does not mean that all 53,882 vehicles have defective components.

Malaysia has also experienced separate incidents

The latest development comes amid several rear axle-related concerns involving the Omoda 5 in Malaysia.

On 6 October 2026, an Omoda 5 reportedly experienced rear axle detachment while being driven. Following the incident, the Road Transport Department (JPJ) suspended the model's Vehicle Type Approval (VTA), temporarily halting new registrations while investigations are carried out.

Separately, Chery Malaysia initiated a recall involving 8,878 pre-facelift Omoda 5 C and H vehicles for inspection and component replacement.

This follows an earlier recall in 2024 involving 600 Omoda 5 vehicles after another rear axle-related incident. At that time, Chery attributed the issue to welding equipment miscalibration following the replacement of a welding tip. Chery's chairman subsequently apologised over the Malaysian incident.

Different recall figures, but an important distinction

China's latest recall covers approximately 6.1 times the number of vehicles involved in Malaysia's separate 8,878-unit campaign.

However, the two recall campaigns should not automatically be treated as having the same root cause. SAMR has not confirmed a common technical cause or established a link between the affected production batches in China and Malaysia.

The latest development puts renewed attention on vehicle manufacturing quality, welding process control and the importance of effective quality assurance throughout the automotive supply chain, particularly as manufacturers expand production across international markets.

Advertise with AutoPulse Malaysia

Put your brand, products or promotion in front of Malaysia’s automotive community.

Send an advertising inquiry